Connect your computer to the admin interface on the master board.
1. Open your web browser.
2. In the address bar, enter: http://192.168.207.1 A browser window similar to the one shown in the figure
below will display.
3. Enter cli as the default user name and new5cli as the default password. You are now ready to begin
configuring your Brivo control panel.
IMPORTANT NOTE: Brivo strongly recommends that you change the default password when you first access the Administrative Interface. Instructions on how to do this are found on the System tab under the Administration subtab.
NOTES:
Your computer should get an IP via DHCP from the panel in the range of 192.168.207.2-192.168.0.255. If you don't get an IP address, set your computer to ip:192.168.207.5 subnet 255.255.255.0, leaving the gateway blank so you can still use your wifi to be on the internet.